What are the Common Faults in the Cone Crusher2020-04-13

Summary´╝ÜWhat are the common faults of the lubrication system in the cone crusherIn the whole cone crusher, it is composed of frame, hydraulic system, power system, crus

What are the Common Faults in the Cone Crusher

What are the common faults of the lubrication system in the cone crusher

In the whole cone crusher, it is composed of frame, hydraulic system, power system, crushing system, lubrication system, control system, etc. Any system failure will affect the production efficiency of cone crusher, so we should regularly, Regularly check the internal conditions of the crusher. After the lubrication system in the cone crusher is abnormal, it is likely to cause other systems to fail to operate normally. A series of failures will cause the entire machine to paralyze and be forced to shut down. Common failures of the cone crusher lubrication system include unreasonable lubricating oil temperature, unreasonable oil flow, turbidity, reduced cleanliness, and excessive lubrication. This article shares with you the common failures of cone crushers and the corresponding solutions.

Common failures of cone crusher and corresponding solutions

Cone Crusher

1. The lubricating oil temperature of the cone crusher is unreasonable Below we mainly analyze the phenomenon of the lubricating oil temperature rising. If the cooling fan is abnormal, it accumulates too much dust, etc., resulting in poor heat dissipation, and the internal heat is not Discharge in time, causing the temperature of the lubricating oil to rise; when the iron inside the cone crusher causes the parts to burn out, a large amount of heat is generated and the temperature of the lubricating oil increases. We should overhaul the cooling fan in time and avoid foreign matter entering the crushing cavity.

2. The cleanliness of the lubricating oil of the cone crusher is low when the dust seal in the cone crusher is damaged or the gap is too large, the dust and dust outside the machine enter the machine, causing excessive impurities to be mixed into the lubricant and clean Degree is reduced. For this reason, the staff should replace the damaged seal ring and adjust the gap reasonably.

3. Excessive lubrication of the cone crusher the amount of lubricating oil in the cone crusher is not as much as possible, a large amount of lubricating oil is added to the lubrication system, and these lubricating oils are not discharged in time, the difference between the two is too The main reason is called over-lubrication. This phenomenon will cause the bearing temperature to increase and the life to be shortened. Therefore, we should add a reasonable amount of oil and observe the smooth flow of oil.

Next : How to Choose Stone Crushing Equipment

Hot Sale

Submit Your Request Here